Click on the button to watch a video on this issue
A downloadable PDF Troubleshooting Card
is available in the description of the video
A toolpath was not created for the Molding Toolpath.
Likely Cause
There isn’t enough space for the full molding profile to fit along the rail contour without overlapping itself or there are no vectors selected
What to Check
- Verify the rail contour length is sufficient for the selected molding profile
- Check for tight curves or short segments in the rail that could cause overlap
- Confirm the profile orientation is correct (no flips or reversals)
- Ensure the profile size matches the scale of the rail
How to Fix
- Reduce the size or depth of the molding profile
- Edit or simplify the rail geometry (smooth sharp curves, extend length)
- Try a smaller cutter or adjust tool settings if applicable
- Recreate the toolpath after making changes